Ultra-Broadband High Power, SSPA
| Part Number | Environment | Min/Max Frequency | Power Out (W) typical | VDC Input | Operating Temp (Degrees C) | Size (W x L x H) | Enable/Disable (uSec) Typical |
|---|---|---|---|---|---|---|---|
| SSPA 2.0-6.0-100 | Ground/Air | 2.0 - 6.0 GHz | 100 | 28 Vdc | -40 to +85 | 3.4 x 6.9 x 1.5 | 10 |
Aethercomm Model Number SSPA 2.0-6.0-100 is a high power, Gallium Nitride (GaN) solid state power amplifier module that operates from 2.0-6.0 GHz.
This SSPA module is packaged in an enclosure that is optimized for high altitude operation along with high performance shock and vibration. Nominal output power is 100 watts typical. Typical small signal gain is 56-62dB. The typical composite power added efficiency with a CW input is 28 % at saturation. Input and Output VSWR is 2.0:1 typical. This solid state power amplifier can be blanked on and off in less than 10 uSec. Standard features include reverse polarity protection and output short and open circuit protection. There is an over-temperature and over-voltage fault in this module. This ultra-broadband power amplifier module operates from –40°C to +85°C base plate temperature. This solid state power amplifier operates from an input voltage of +18 to +32 Vdc but the nominal applied voltage is +28 Vdc.
This high power SSPA is employed in high shock and vibration environments and can be used on board many different types of airborne platforms. It is designed and tested to withstand MIL-STD-810 high shock and vibration requirements. Noise figure at room temperature is <12 dB. The housing volume is approximately 3.4”(W) x 6.9”(I) x 1.5”(H) and the power amplifier weighs 3.0 lbs maximum. DC and logic connections are accessible via a DSUB connector. The RF input connector for the solid state power amplifier is an SMA female. The RF output connector is a TNC female. Typical transmit test data appears on page two of this data sheet at room temperature. For mounting and heat sink instructions, further test data or operation and logic and pin out requirements, please contact an expert below.
This is an example of a Frontgrade Aethercomm standard product. Frontgrade Aethercomm designs and manufactures high performance, high power CW or pulsed SSPA’s for commercial, military and satellite communications customers.
• Operation from 2.0 to 6.0 GHz
• Composite PAE of 28% at Pout max
• GaN Technology
• 100 watts Saturated Power Output typ.
• +18 to +32 Vdc Operation (+28V Nominal)